Cut with:
GlitterFlex Black & Red
There are two designs in the SVG file for you to use.  The red and green design is layered.  The red & black one is separated into pieces for when you can't layer.  For best results, use the layered red & green one.  ThermoFlex is great for layering! GlitterFlex is not recommended for layering.  There is always a bit of shrinking of htv and therefore, when using the separated one, you may get a bit of spacing in between pieces.  This won't happen with the red & green file.  Just be sure you know if the vinyl you choose can be layered.

SVG Files are meant for cutting machines such as the Silhouette Cameo, Cricut and Scan n Cut.

The files are offered in SVG only and you will need to convert them to the format of your choice.

We are letting you know what vinyl we cut the design with.  What you chose to cut the design on may change the outcome.

We use nothing but quality vinyl and they  are cut on a Silhouette with a CB09 Blade available at www.GaylesNest.com

Resizing is done at your own risk.  Resizing too small will make weeding difficult in some cases.  
All designs have been tested for quality and the picture you see is the actual design cut piece.

All design files are downloadable within 24 hours if not sooner after payment verification.

No refunds on any transmitted file.

By paying for these files, you agree to the terms and conditions. If there is an error on our part, we will of course fix it for you.